1. Disconnect battery.
2. Pull control knobs from radio.
3. Remove radio molding.
4. Unclip molding for control unit
5. Remove both screws from left and right top
6. Slightly pull out holder for control unit at top and then lift out in upward direction.
7. Pull off electric plugs on left and right, as well as sockets for instrument lights.
8. Remove three screws on the front of the unit
9. Remove control unit.

1. Place control unit into holder and install the three front screws.
2. Plug in 12 pin electric plugs left and right and lamp socket for instrument lights.
3. Insert holder for control unit from above into cutout and press on top left and right side, gently.
4. Fasten both screws at left and right top.
5. Clip-in molding for control unit.
6. Press-on radio molding.
7. Plug-on control knobs of radio.
8. Connect battery.
9. Check function of ACC

 

All information provided here is for guidance only. Green Eye Auto Parts does not accept responsibilty for any damage or injury caused. If in any doubt, have the part removed by a professional.